|
Post by TRow on Mar 28, 2005 0:34:55 GMT -5
The Card I was sent was a Sapphire X800Pro VIVO with 1.6ns RAM. The 4 pipes were in fact unstable, and showed heavy corruption with Pro and XTPE Bios. I almost sh*t when I thought I fried this card but luckily it can all be reversed. I had to flash a special empty.bin bios to clear the Pipe mod, and luckily I was able to convert to factory conditions. The card may have some overclock potential, but its definately a no go for converting. I reinstalled the ATi 4, even though I may water cool it soon. Heres a updated pic. EDIT: Notice the Black Nylon Cable Tie protruding from the Empty Rear Exhaust Grill? Thats for stability due to the sh*tty PCI Slot Mechanism. The Weight of the ATi 4 is too much for the Latch. T.RoW
|
|
|
Post by devnull on Mar 28, 2005 0:36:13 GMT -5
that is sooooo sweet looking. Thats some fat pipe you got running that water through, looks SO good.
|
|
|
Post by TRow on Mar 28, 2005 4:10:09 GMT -5
I got bored tonight and and Installed the Danger Den Acetal GPU Block back on. I did what any reasonably insane person would do from this forum;D Took about 2 hours to drain, install, and refill. It will take a few hours for the water to stabilize, the foam is caused by "Water Wetter" and heavy doses of UV Dye. Heres a updated photo in True Cruiser Fashion
|
|
|
Post by TRow on Mar 28, 2005 16:53:46 GMT -5
Update on Idle/Load Temps: HL2 & UT2k4 Ambients: 73F X800Pro 500/540 After the water has stabalized for 15 hours. T.RoW
|
|